Re: RUNSQL Command: Help & Escape Messages

[CRPence <CRPbottle@xxxxxxxxx>]

On 13 Nov 2012 18:07, Vernon Hamberg wrote:
> Are you running the command only from a command line? It might not
> throw an escape message there - some commands are like that. Try it
> in a program.

  The OP has apparently already concluded that the "error" is sent only 
as a Diagnostic, so FWiW:

  If "command line" implies [QCMD] Command Entry, then there is 
unlikely a difference between an invocation from a program and the 
Command Entry panel, because the QCMD request processor should react 
quite similar to the program.  What sometimes is a source of confusion 
however, is that a "MENU" might change the message to a diagnostic due 
to Move Program Message processing [effectively from the CPP and to 
QUIMNDRV; the "move" changes the message type to Diagnostic], or a [Work 
with] "Panel Group" command line might send an additional copy of the 
Escape message as an Informational message [from QUOCMD to QUOMAIN].  In 
the latter case, the original message would likely remain, showing the 
original Escape message; F10=Messages from F1=Help, or DSPJOBLOG would 
show the two messages.