Re: VPN & Client Access

[Booth Martin <booth@xxxxxxxxxxxx>]

Now wasn't that easy.  Thanks Steve.  I owe you a beer.


On 12/13/2013 10:41 PM, TheBorg wrote:
> Booth -
>
> Configuration is required for the VPN client on your PC, usually by the
> system administration group or they give you the host name/ip address
> information and instructions on how to configure it yourself.
>
> After the client is properly configured, you must login to the VPN client on
> your PC and start a session with the host system.  Once the VPN connection
> is established, it is like your PC is on their local network and you can
> then open the IBM i applications and get connected to the IBM systems.
>
>
> "Booth Martin"  wrote in message
> news:mailman.2415.1386995257.2717.midrange-l@xxxxxxxxxxxx...
>
> I suspect I am about to look like an idiot again.  No big deal.  I am
> used to it.
>
> Is there a tutorial or instructions on how to connect with VPN?
>
> I have Client Access, iSeries Navigator, and RDi.  I have used VPN with
> Client access but that setup was in 2009 and I have no idea how I did it
> back then,
>
> The VPN I am trying to use to connect is: SHREW SOFT VPN CLIENT That
> installed, and it shows as connected when I start it.  But I can't
> figure out what to do next.