On 28-Aug-2014 10:42 -0500, Peter Dow wrote:
When I enter WRKOBJ at a command line and press F4, I'm shown the
Major Command Groups menu, as if it did not see the WRKOBJ I entered.
And the effect from typing a non-existence command name followed by
F4=Prompt? The expected CPF0001 preceded by a diagnostic CPD0030
"Command &2 in library &3 not found."; similar variations of a test of
the F4 effect for a command string that should knowingly effect CPF0001
arising from any of the various other CPD003# message conditions [or
similar] might reveal something not conspicuous when using a command
that knowingly should prompt without errors.
Of course, a circumvention is to precede the command-string with a
question mark (?) character and press Enter instead; to effect what the
F4=Prompt should have done. For example: ?WRKOBJ
However, if I enter WRKOBJ X, it tells me it cannot find X.
Conspicuous in the difference between that and the failing F4,
pressing Enter does not invoke the Command Prompter (PT) feature.
I'm using TN5250J version 0.7.3 (my prime suspect) to connect to an
IBM i with OS 7.1, PTF group SF99710 level 13037 (low on my list of
suspects).
I've tried it with two different profiles, and it really seems hit
or miss. Sometimes it works, but mostly it doesn't. Prior to today,
it has worked flawlessly.
If the problem consistently stops occurring [or consistently occurs]
when debug is active in the job, then the issue might arise from an
issue with uninitialized storage in a system program.
Anyone seen anything like this?
Never. But I have seen my share of bizarre effects over the years;
when I had access to the code long before being publicly released :-)
The spooled output from a Trace Job (TRCJOB) likely should help to
identify the origin of the issue. The TRCJOB is replaced with Start
Trace Job (STRTRCJOB) as I recall, but TRCJOB should still function fine
to produce a spool of the tracing] Apparently the CA04 is properly being
sent, else the GO MAJOR would be even less likely than any other effect.
Given the PF4 seems to have been processed by the OS, seems somewhat
unlikely to be the fault of the emulator; as well, the fact that a
cursor positioning issue should have effected CPD6A6D "Additional
Message Information".
If traced [I would be willing to review], probably best that the
request is started from a separate job after Start Service Job
(STRSRVJOB) of the job that will reproduce the issue; a trace of the
_exact same action_ for a non-failing scenario would be required for
comparison.
midrange.com
