I have my old Power 6. It has a mix of 0595's, CEC, 5886, 5787 The disk
drives used to be used by other lpars of IBM i. I have initialized the
system down to one lpar of IBM i and one lpar of Linux. I cannot add
these remaining IBM i disks into an asp. They all show up as
nonconfigured units.
I have added disks from the three units shown and from the same Sys Bus
and Sys Card shown.
System Service Tools (SST)
3. Work with disk units
2. Work with disk configuration
2. Add units to ASPs
3. Add units to existing ASPs
No Non-Configured Units
The function you requested cannot be performed at this time
because:
o The requested function requires one or more non-configured
units. No non-configured units were found on the system.
This condition must be corrected before the requested function
can be performed.
The following are the recommended recovery procedures:
o If there are non-configured units connected to the system,
ensure that all such units are powered on and are cabled
correctly. If all non-configured units are powered on and
are cabled correctly and this error still occurs, call for
service.
System Service Tools (SST)
3. Work with disk units
1. Display disk configuration
4. Display non-configured units
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.