Re: LIC Install - Valid Load Source Not Found

[DrFranken <midrange@xxxxxxxxxxxx>]

Careful on the disk features. If you order a FC #6718 for example you'll 
get the correct Disk Unit but in a sled for a 270 not a 250. You'll want 
a FC 6818 for this machine.

Also be careful on O/S, I can't recall fore sure if V5R3 supported the 
35GB Version for example. (I think so but I've slept since then... :-) )

        - Larry "DrFranken" Bolhuis

www.frankeni.com
www.iDevCloud.com
www.iInTheCloud.com

On 6/19/2015 10:48 AM, Holger Scherer wrote:

> Hi Milosz,
> must be an IBM disk, 9406-250 supports 6607, 6613, 6717, 6718, 6719 only.
>
> -h
>
> Am 19.06.15 um 16:04 schrieb Milosz Jedynak:
> > Hello list,
> >
> > I'm trying to revive an old 9406-250 system. It had no hard disks, so I
> > bought a non-ibm (hitachi) ultra320 scsi disk. When I boot V5R3 from a cd
> > and try to install LIC, the system complains that there is no specific
> > load
> > source unit (type 6718), which imho was present on the system in the
> > past.
> >
> > Can LIC be installed on any hard disk or it must be an ibm disk (type
> > 6718) or the original load source disk (which I don't have)? Not sure if
> > it's an issue, but when I check hardware resources using DST there is
> > nothing related to the new hard disk, optical and tape devices are
> > visible.
> > All other menus e.g. work with disk units report that there are no
> > non-configured disks. Any ideas?