Two of the Ethernet Ports aren't showing any config attached, even though I know one is the console port. I'll need to check the NIC itself to see which port is the console.
-----Original Message-----
From: Bryan Dietz [mailto:bdietz400@xxxxxxxxx]
Sent: Thursday, October 15, 2015 8:10 AM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Subject: Re: Configure NIC port
I usually start with:
WRKHDWRSC *CMN
find the card and you will see the resource names assigned to the ports.
CRTLINETH for the port without a configuration attached to it. If it is plugged into a network device(switch,router) when you vary it on its status should show VARIED ON
as an aside, assuming the console port is LAN CONSOLE, I have created a line description that documents its use as console with ONLINE(*NO).
bryan
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
