RE: Printer recommendations?

I think somebody else mentioned Okidata.

We also run an Epson LQ570 via a remote writer to a
site over 1000 miles away. I seems to work fine and
has been pretty reliable.

It was a fairly cheap unit ($300-$400) and the duty
load is about the same (<35 BOLs per day).


Terry


-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bob Cagle
Sent: Wednesday, May 25, 2016 2:02 PM
To: Midrange Systems Technical Discussion
Subject: RE: Printer recommendations?

Our usage will be even less than 35 per day, so cost is a factor as well - management isn't going to want to spend more the $500-$1000. Limits me quite a bit.

Thanks
Bob

-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Winchester Terry
Sent: Wednesday, May 25, 2016 10:38 AM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Subject: RE: Printer recommendations?

We use IBM 6500 printers for our 4-part BOL's.

These are setup as a *LAN connect, *IPDS printers.

They're pretty reliable...but we're only printing about 35 BOLs per day so YMMV.

Terry


-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bob Cagle
Sent: Wednesday, May 25, 2016 11:29 AM
To: MIDRANGE-L@xxxxxxxxxxxx
Subject: Printer recommendations?

We have an old Genicom 930 line printer (really just a rebranded Okidata). It's connected to our System i with a parallel port to twinax converter box/pigtail thingy (yes, that's the correct technical term - thingy!).

We use this to print our multi-part BOL forms.

I would love to modernize this with a laser printer and NCR paper, but I don't have upper management or user support to do so.

The problem with the current setup is that quite often the communications get hosed and the writer on the i reports it as a hardware failure. It usually takes several power cycles of both the printer and the converter box, plus varying on/off the device to get it to work again.

Since I can't currently switch this to a laser, I was wondering if there was an Ethernet based line printer that would well with the i. Any recommendations?

Does anyone have any advice or similar experiences to share?

Thanks

Bob Cagle
IT Manager
Lynk
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a moment to review the archives at http://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related questions.

Confidentiality Notice: The preceding e-mail message (including any attachments) contains information that may be confidential, protected by applicable legal privileges, or constitute non-public information. It is intended to be conveyed only to the designated recipient(s). If you are not an intended recipient of this message, please notify the sender by replying to this message and then delete it from your system. Use, dissemination, distribution or reproduction of this message by unintended recipients is not authorized and may be unlawful.