Re: Post-mortem on v7r1 to v7r3 upgrade

[DrFranken <midrange@xxxxxxxxxxxx>]

Just for the record I run this before and after EVERY upgrade. Been 
doing it since, like forever ago, when it turned out to be the needed 
magic. Even on some pretty large systems it takes little time and is 
worth the insurance.

With *CHECK around now that is certainly an option to save some minutes.

        - Larry "DrFranken" Bolhuis

www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.

On 11/6/2017 1:08 PM, Justin Taylor wrote:
> RCLSTG SELECT(*DBXREF) was it.  IBM found it by RCLDBXREF *CHECK.
>
>
>
> -----Original Message-----
> From: Rob Berendt [mailto:rob@xxxxxxxxx]
> Sent: Friday, November 03, 2017 9:37 AM
> To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
> Subject: RE: Post-mortem on v7r1 to v7r3 upgrade
>
> Again, it's one of those pain memories dwindling out of memory but something sounds vaguely familiar about RCLSTG.
> One may wish to run RCLSTG SELECT(*DBXREF) after an upgrade.
>
> I think there is a new command as a companion to RCLSTG SELECT(*DBXREF) Check out RCLDBXREF OPTION(*CHECK) RCLDBXREF OPTION(*FIX)
>
> I also always run a CHKPRDOPT *OPSYS  after an upgrade.
>
>
>
> Rob Berendt
> --
> IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600 Mail to:  2505 Dekko Drive
>            Garrett, IN 46738
> Ship to:  Dock 108
>            6928N 400E
>            Kendallville, IN 46755
> http://www.dekko.com