Re: 8203-E4A with corrupted service processor

AFAIK no "hard reset" on P6 and above hardware. Can't understand how you
could kill the FSP with a reset. It takes a long time (5+ minutes) but
always ends... If you had VIOS you supposedly had an HMC, why do baremetal
when you have an HMC?
I've seen c1001029 on machines without the VPD Card (forgot to plug it
after replacing a board...)...

Best Regards,

Roberto

On Thu, Mar 1, 2018 at 4:05 PM, Diego Kesselman <diegokesselman@xxxxxxxxx>
wrote:

Have you tried to move the 2 dip switches to perform the hard reset?


El 01/03/18 a las 13:01, Adam Stouffer escribió:

date: Thu, 1 Mar 2018 08:49:00 -0500

from: Jack Kingsley <iseriesflorida@xxxxxxxxx>
subject: Re: 8203-E4A with corrupted service processor

Couple of google searches that I found show a bad service processor card.

Yeah I know its bad. My question is can be be replaced or
reprogrammed? I looked all through the docs and there is no FRU part
number or any diagrams of where its located. It looks like its built
onto the motherboard.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: http://amzn.to/2dEadiD