Re: Network setup for sharing imagecatalog.

[DrFranken <midrange@xxxxxxxxxxxx>]

Good document there but one comment. They speak about adding host table 
entries but I've done a hundred of these easy and never added a host 
table entry for this even once.

        - Larry "DrFranken" Bolhuis

www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.

On 5/4/2018 4:01 PM, Kevin Bucknum wrote:
> Probably a better doc out there, but I'm working off of this one:
>
> http://www-01.ibm.com/support/docview.wss?uid=nas8N1013479
>
>   
>
> I already have a virtual connection between my two lpars on the same
> box.
>
>   
>
> F5 on both basically looks like this:
>
>   
>
> Resource name . . . . . . . :              VLAN ID    0
>
> Adapter type  . . . . . . . : *NON
>
> Adapter serial number . . . :
>
>                                                                  
>
> Host name for service tools :
>
> Node  . . . . . . . . . . . : 000000000000
>
> Duplex  . . . . . . . . . . : AUTO
>
> Network speed . . . . . . . : AUTO
>
>                                                                  
>
> IP version allowed  . . . . : BOTH              IPV4, IPV6, BOTH
>
> Internet address  . . . . . : 0.0.0.0
>
> Gateway router address  . . : 0.0.0.1
>
> Subnet mask . . . . . . . . : 255.255.255.0
>
>                                                                  
>
> IPV6 address  . . . . . . . :
>
> IPV6 interface ID . . . . . : 0000000000000000
>
> DHCP unique ID  . . . . . . : 0000000000000000000000000000
>
>   
>
> F13 lists no devices. F21 lists three resources. Those are currently
> used by line configs pointing to DMZ, Internal network, and Virtual over
> the backplane.
>
>   
>
> The way I read that doc what I can do is to end the virtual interface
> and vary the line off. That will make it available to F13. From F13 I
> can set up the new information. Can I use a different IP that is valid
> across the virtual network? Once I'm done it reads like I can vary the
> old virtual back on, and start the interface, and it should talk to both
> IP's. Is my reading of that correct?