Interface for that IP / Line was created, but I forgot to start it.
Normally autostarts from an IPL.
ETHAGG ACTIVE
ETHAGNET ACTIVE
ETHAGTCP ACTIVE QTCPWRK QSYS 793431
1) Now I need to create some processes that will send a large amount of traffic.
2) How can I test the load balance and the failure
Paul
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bryan Dietz
Sent: Friday, October 26, 2018 9:02 AM
To: Midrange Systems Technical Discussion
Subject: Re: How to configure a 2nd Enthernet port to a 2nd Eternet Switch for Load balancing/fail over
they will not "create" until you configure a TCPIP address for that line
Bryan
Steinmetz, Paul wrote on 10/26/2018 8:46 AM:
The line is now varied on successfully.
However, the Ethernet Controller and Device that are normally auto created did not create.
What am I missing here?
ETHAGG VARIED ON
ETHERLAN01 VARIED OFF
ETHERNET01 VARIED OFF
ETHERTCP01 VARIED OFF
Paul
This mailing list archive is Copyright 1997-2026 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
