Thanks everyone, we're good.
P9 all racked and cabled.
Rails were a night mare, all different, the documentation was not totally accurate.
9009-42A and 7316 Flat panel console rails weren't bad.
Improper screws, (wrong thread size) for attaching Flat Panel to the flat panel rails.
EXP24SX storage enclosure and 7063-CR1 rails, that's another story.
On to HMC configuration.
Except for the HMC ip, would be acceptable to mirror the settings from my P7 HMC, 7042-CR6?
Let the fun begin.
Paul
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jim Oberholtzer
Sent: Thursday, December 06, 2018 2:47 PM
To: 'Midrange Systems Technical Discussion'
Subject: RE: P9 racking/rail questions/issues
The P9 is 3/4 inch beyond a P8 or P7 server? If so, then look to see if you
put a screw in the front of the rail BEFORE you pushed in the server. I'll
bet it's hitting a screw. If it's the same as the P8/P7, that's where its
supposed to be.
The HMC does not have rails that allow it to be pulled out like the earlier
HMCs did. There is no provision for that in the rail. Both Steve and I
alluded to that earlier when we told you there was no cable management arm
for the HMC.
--
Jim Oberholtzer
Agile Technology Architects
-----Original Message-----
From: MIDRANGE-L <midrange-l-bounces@xxxxxxxxxxxx> On Behalf Of Steinmetz,
Paul
Sent: Thursday, December 06, 2018 1:38 PM
To: 'Midrange Systems Technical Discussion' <midrange-l@xxxxxxxxxxxx>
Subject: P9 racking/rail questions/issues
1)The front of the 9009-42A server extends 1/2 to 3/4 inches past any other
device in the rack.
It appears to be mounted correctly and is pushed all the way in.
Is this normal for P9 servers, or do I have a rail/rack issue?
2) When pulling out the HMC, it only extends 1/2 way, not fully like the
9009-42A.
Is this normal for the 7063-CR1, or do I have a rail/rack issue?
If engaging the release buttons, the HMC then extends further, but becomes
released from the rails.
Thank You
_____
Paul Steinmetz
IBM i Systems Administrator
Pencor Services, Inc.
462 Delaware Ave
Palmerton Pa 18071
610-826-9117 work
610-826-9188 fax
610-349-0913 cell
610-377-6012 home
psteinmetz@xxxxxxxxxx
http://www.pencor.com/
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe,
or change list options,
visit:
https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at
https://archive.midrange.com/midrange-l.
Please contact support@xxxxxxxxxxxx for any subscription related questions.
Help support midrange.com by shopping at amazon.com with our affiliate link:
https://amazon.midrange.com
midrange.com
