Re: [Power9 with Direct Attached V50x0

[Diego Kesselman <diegokesselman@xxxxxxxxx>]

Thank you both! That was the issue!

I changed the value to "transitional" and worked on first attempt

Regards

Diego E. KESSELMAN

El 29/07/19 a las 12:18, Steve Pavlichek escribió:
> Kristopher does bring up a good point. Double check that the FC ports being used on the v5000 show as “Host IO Permitted”. The fctargetportmode may be set wrong on the v5000. It must be Disabled or Transitional.
>
> v5000 CLI command
> Lsiogrp 0
>
> Look for fctargetportmode
>
> From: Diego Kesselman<mailto:diegokesselman@xxxxxxxxx>
> Sent: Monday, July 29, 2019 12:39 PM
> To: midrange-l@xxxxxxxxxxxxxxxxxx<mailto:midrange-l@xxxxxxxxxxxxxxxxxx>
> Subject: Re: [Power9 with Direct Attached V50x0
>
> We don't have virtual wwpns. I remember you need a SAN Switch for that.
>
>
> El 29/07/19 a las 11:33, Kristopher Whitney escribió:
> >      You need to disable the virtual wwpns (NPIV) on the V5K controller.
> >
> >
> >
> >      -
> >
> >        message: 1
> >        date: Mon, 29 Jul 2019 15:19:32 +0000
> >        from: Tsvetan Marinov <tsetso.marinov@xxxxxxxxx>
> >        subject: Re: Power9 with Direct Attached V50x0
> >
> >        If this is a new V5K, what version of the firmware it is at the moment
> >        and what firmware version it wa shipped with l?