We're on V7R3, VL910_122/FW910.20 and MH01799 as *ACTIVE/TEMP/*PERM for firmware for a Power 9 9009-41A. Our HMC is a 7063CR1 on 9.1, service 940 and Build 1911021524.
I can find directions for prior versions of the HMC that indicate I could pre-download a new version of the firmware for later install. On this version, I am not finding the same "Advanced" options that allow making the changes to download only. I start the process, select to go to IBM's repository and get a list of 5 LIC Levels I can pick. The note above states "Select the LIC level you want for the displayed LIC type. Select None if you do not want to update that LIC type". The note below states that "The LIC level selected above will be used to update the components listed below".
If I use this, will I get an option later to say that I just want to save the firmware for install later? There's none of the feel that I remember: that I knew it was just going to download and not peremptorily shut down the system to install the update.
_____________________________________________________________________
Spirax-Sarco Engineering Plc. This e-mail has been scanned for viruses by Cisco Cloud Email Security.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
