Re: End an Active Job With a Dump?

Personally I prefer to STRSRVJOB and then STRDBG. A static dump of the job
might give you some clues as to what is going on, but actually stepping
through the job (in debug mode) beats a static dump (in my mind) every
time. Though I admit I'm normally looking more at mis-functioning code
than performance issues within the code.

On Mon, May 11, 2020 at 4:56 PM Kevin Monceaux <Kevin@xxxxxxxxxxxxxx> wrote:

Roberto,

On Sun, May 10, 2020 at 06:56:25PM +0200, Roberto De Pedrini wrote:

did you tried with ENDJOBABN ... some times it stops jobs not stopped

with

ENDJOB

No. EndJob would end them. We were able to get some dumps with
StrSrvJob/DmpJob. Progress is being made on their underlying performance
issues.


--

Kevin
http://www.RawFedDogs.net
http://www.Lassie.xyz
http://www.WacoAgilityGroup.org
Bruceville, TX

What's the definition of a legacy system? One that works!
Errare humanum est, ignoscere caninum.
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxxxxxxxx
Before posting, please take a moment to review the archives
at https://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxxxxxxxxxx for any subscription related
questions.

Help support midrange.com by shopping at amazon.com with our affiliate
link: https://amazon.midrange.com