Re: adding exit pgm issue

[Peter Dow <petercdow@xxxxxxxxx>]

Hi Jay,

Not sure if this will help, but there was a thread about this on 
midrange.com 
(https://archive.midrange.com/midrange-l/201710/msg00072.html)  that 
provided this link:

https://www.ibm.com/support/pages/message-cpf3c83-andor-cpf3ce5-during-qusrsys-or-other-lpp-installation

which has this:

"The exit program must be authenticated before it can be changed or 
added. If the message CPF3CE5 is received, then most likely it is 
because the exit program listed in the message has been changed. This is 
usually a result of restoring unsupported previous release data to a 
current release system (such as restoring V4R4M0 data to a V5R3M0 system)."

--
*Peter Dow* /
Dow Software Services, Inc.
909 793-9050
petercdow@xxxxxxxxx
pdow@xxxxxxxxxxxxxx /


On 10/25/2022 6:16 AM, Jay Vaughn wrote:
> Can anyone tell me why this is failing, or what steps are required to get
> it to add?
> It works fine on one 7.4 system but not another 7.4 system.
> There is currently nothing on the exit point prior to issuing the command.
>
> ADDEXITPGM EXITPNT(QIBM_QP0L_SCAN_CLOSE) FORMAT(SCCL0100) PGMNBR(1)
> TEXT('Exit Program') PGM(myLib/myExitPgm) THDSAFE(*YES) MLTTHDACN(*SYSVAL)
> PGMDTA(*JOB *CALC 'QSECOFR   xxxxxxxxxxx.xx       00000       ')
>
>
> joblog...
>
>
> Message ID . . . . . . :   CPF3CE5       Severity . . . . . . . :   40
>
> Message type . . . . . :   Escape
>
> Date sent  . . . . . . :   25/10/22      Time sent  . . . . . . :
> 13:58:25
>
>
> Message . . . . :   Exit point QIBM_QP0L_SCAN_CLOSE with format SCCL0100
> will
>    not allow exit program myExitPgm library myLib to be added.
> Cause . . . . . :   The Preprocessing Exit Program for Add for the exit
> point
>    denied the request to be added.
>
> Recovery  . . . :   Refer to the exit point provider's documentation for
>
>    further information.
>
>
> tia
> Jay