RE: Barcodes

["Bob Cozzi" <cozzi@xxxxxxxxx>]

X'25' is the "correct" linefeed character. Original IBM documented X'15' as
linefeed in much of its documentation but that was not always correct. X'25'
is what you want to use when doing CGI RPG programming or using an ASCII
device such as a scanner.

-Bob Cozzi
www.RPGxTools.com
If everything is under control, you are going too slow.
- Mario Andretti


-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Fleming, Gregory (ED)
Sent: Friday, March 11, 2005 3:17 PM
To: 'rpg400-l@xxxxxxxxxxxx'
Subject: RE: Barcodes

Eureka !!!

 

That works.  Also, I needed to use hex 25 instead of 15 for the line feed.  

 

Thanks

 

Greg

 

-----Original Message-----
From: Andy Renk [mailto:acr12345@xxxxxxxxxxxxxxxxx] 
Sent: Friday, March 11, 2005 3:04 PM
To: Fleming, Gregory (ED)
Subject: Barcodes

 

When you compiled the print file did you change the replace unprintable
char.  From *YES the default to *NO?

 

Andrew Renk
Sr. Programer
Chambers & Owen, Inc.
  

 

-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.