%lookup on compile time array

[RPower@xxxxxxxxxx]

Can %Lookup be used on a compile time array such as a table?  I have two 
tables defined, the lookup on one, will give the matching on the other. 
Code:
     c                   If        %Lookup(epenst:tabs) > 0      Nov 07/05 
R.Power
     c                   Eval      penstat = tabx      Nov 07/05 R.Power
     c                   Else                                              
     Nov 07/05 R.Power
     c                   Eval      penstat = 'UNKNOWN'      Nov 07/05 
R.Power
     c                   EndIf                                             
     Nov 07/05 R.Power
I'm trying to replace the old code of:
     c*     epad          lookup    tabs          tabx 60    JUN 8/92 MT
     c*                   if        *in60 = *on
     c*                   eval      status = tabx       JUN 8/92 MT
     c*                   endif  
However I'm getting errors on the %Lookup.  Any ideas?


Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
709-576-8132
rpower@xxxxxxxxxx
http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill