Re: Probem w/ bad data during subfile load

["Michael Ryan" <michaelrtr@xxxxxxxxx>]

You're probably getting that error becuase you're calling MYPGM and not
passing the correct parameters.

On 6/5/06, steema@xxxxxxxxxxxxx <steema@xxxxxxxxxxxxx> wrote:
> HI - I am getting this error cond. during the subfile load. Is there a way
> to monitor for it and bypass so that the subfile doesn't hang? thanks,
> Steve
> Message ID . . . . . . :   CPF9999       Severity . . . . . . . :   40
> Message type . . . . . :   Escape
> Date sent  . . . . . . :   06/05/06      Time sent  . . . . . . :
> 08:59:43
>
> Message . . . . :   Function check. MCH3601 unmonitored by MYPGM at
>    statement 0000000054, instruction X'0000'.
> Cause . . . . . :   An escape exception message was sent to a program
> which
>    did not monitor for that message. The full name of the program to which
> the
>    unmonitored message was sent is MYPGM MYPGM MYPGM. At the time the
>    message was sent the program was stopped at higher level language
> statement
>    number(s) 0000000054. If more than one statement number is shown, the
>    program was a bound program. Optimization does not allow a single
> statement
>    number to be determined. If *N is shown as a value, it means the actual
>    value was not available.
> Recovery  . . . :   See the low level messages previously listed to
> locate the
>    cause of the function check.  Correct any errors, and then try the
> request
> --
> This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
> To post a message email: RPG400-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
> or email: RPG400-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/rpg400-l.