RE: RNX9998 error on CHAIN

[smorrison@xxxxxxxxxxxxxxxxxxx]

Check the value of the key field. Also what command did you run to create 
the program?


Steven Morrison
Fidelity Express 
903-885-1283  ext. 479



"Willie J. Moore" <WJMoore@xxxxxxxxxxxx> 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
05/22/2007 01:00 PM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
"RPG programming on the AS400 / iSeries" <rpg400-l@xxxxxxxxxxxx>
cc

Subject
RE: RNX9998 error on CHAIN






This program is pre LE. Did not want to make to many changes at once. When 
I get this program to run, will try the 'if  %found'.
The key is only one field (salesperson no).

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx
[mailto:rpg400-l-bounces@xxxxxxxxxxxx]On Behalf Of Booth Martin
Sent: Tuesday, May 22, 2007 10:16 AM
To: RPG programming on the AS400 / iSeries
Subject: Re: RNX9998 error on CHAIN


I wonder if the issue may be that you are using non-contiguous keys this 
time?

Also, why the 45? 

c        if      %found

seems so much easier and clearer to everyone.

Willie J. Moore wrote:
> I am getting a RNX9998 error when I try to chain to a file inside a 
RPGLE program.
> Jc6chnb                chain           slsmas 45
> *in45                          ifeq            '1'
>                                end
>
> When I do DSPJOBLOG it says something about Internal Failure in compiler 
or subroutine?
> I ran DBG and it was the chain line that failed.  I then commented out 
the chain and the program ran. 
> I have used chains in the past with data structures in the past with no 
problems.
> Any help or suggesting would be appreciated,
> William Moore