CPF5192 error message with RPG program.

["Steven Harrison" <steven.harrison@xxxxxxxxxxxxxxxxx>]

Hi All,

 

I have been receiving the following error in the job log when my program
runs:

 

Message ID . . . . . . :   CPF5192       Severity . . . . . . . :   50


Message type . . . . . :   Escape


Date sent  . . . . . . :   17/07/09      Time sent  . . . . . . :
10:50:57  

 


Message . . . . :   Data sent to device AFXIT02A not valid.  Negative
response

  code is 10050112.


Cause . . . . . :   The condition was caused by the program output data


  containing below hex 40 or too many input fields.  More information on
the  

  negative response code can be found in either the IBM 5494 Remote
Control   

  Unit Functions Reference (under negative responses) or the SNA Formats


  Manual (under SENSE or LUSTAT codes).  Invalid data (below hex 40) may
have 

  occurred in one of the following ways:
etc etc...

 

followed by:

 

Message ID . . . . . . :   RNX1251       Severity . . . . . . . :   99


Message type . . . . . :   Escape


Date sent  . . . . . . :   17/07/09      Time sent  . . . . . . :
10:50:57

 


Message . . . . :   Permanent I/O error occurred in file STATUSD.
Etc etc...

 

The following is happening:

 

Program 1 displays a subfile containing the discount rates for a price
code. The DDS for this program contains the subfile.

 

Program 2 is a service program that is responsible for displaying a
window that reports any status events that might take place (ie. Could
not find price code, discount rate invalid etc...). The DDS for the
window is in a separate display file. I have never had a problem with
this program and it is used by a number of other programs to display
status events.

 

The error is occurring when Program 2 is called to display the Window.
While trying to figure out what was causing the error I started
stripping out code bit by bit to identify where the problem was
occurring. I ended up removing the subfiles from Program 1's DDS
altogether and ended up with just a Header record displaying a single
text field and a Footer record that contains indicators for the F12 and
F03 keys. It seems that the error is occurring when 'ExFmt' is called in
Program 2 before a read or ExFmt in Program 1. 

 

So with the following code the error would occur:

 

Program 1:

 

Write Header;

DoesPriceCodeExist() <- Procedure to determine if the price code exists.
If it doesn't it sets a status event that can be displayed by Program 2.

 

Call Program 2 <- Calls ExFmt on the Window to display the status event.
The program will fall over at this point.

 

ExFmt Footer;

 

 

But with the following code the error won't occur:

 

Write Header;

ExFmt Footer;

DoesPriceCodeExist()

Call Program 2 <- Display the window reporting that the Price Code
doesn't exist.

ExFmt Footer;

 

 

I'm wondering if anyone can shed some light on why this is happening?
Why will the ExFmt on the Window cause the program to crash if the DDS
it is overlaying has only had Writes to it but it will be fine if the
there has been a previous Read/ExFmt.

 

Both DDS files are compiled with RSTDSP *YES. Also for some strange
reason the error will not occur if I'm running the program in the
Debugger?!?!? Which I find very strange.

 

Any help would be greatly appreciated.

 

Steve