RE: IP address used by Sockets

["Porterfield, Sean" <SPorterfield@xxxxxxxxxxxxxxxxxxxxxxx>]

> -----Original Message-----

> Here's an example, I have multiple IP addresses - one for the i, and the rest for the domino servers hosted on that i.
> Internet         Subnet              Line
> Address          Mask             Description
> 10.10.1.81       255.255.255.0    LANLINGB
> 10.10.1.123      255.255.255.0    LANLINGB

> ...
> They are all on the same subnet.
> They may talk to clients, etc on various subnets.
> Network guy wants special subnet that is running barcode printers to only talk to 10.10.1.211 which is the i, not the Domino servers.
> How would I set up that route?


Where the barcode printers are in 10.10.3.x and your default gateway is 10.10.1.1 (since you didn't specify)

ADDTCPRTE RTEDEST('10.10.3.0')
          SUBNETMASK('255.255.255.0')
          NEXTHOP('10.10.1.1')
          BINDIFC('10.10.1.211')
          DUPRTEPTY(9)

DUPRTEPTY is a number from 1 to 10 with 10 being the highest priority.  Check the routing table to be sure of the number you want to use.
--
Sean Porterfield

This email is confidential, intended only for the named recipient(s) above and may contain information that is privileged.  If you have received this message in error or are not the named recipient(s), please notify the sender immediately and delete this email message from your computer as any and all unauthorized distribution or use of this message is strictly prohibited.  Thank you.