RE: *INQ message sent to *EXT queue via QMHSNDPM not received via QMHRCVPM

Right you are, Vern! Thanks!

It's a shame that's not controllable. The real version of the program has a
procedure for the send and a different procedure for the receive. Since I'm
not aware of a good way to receive messages off of a *PGMQ in another
procedure -- especially for a procedure that's no longer active -- I was
forced to make a new "sendReceveInquiry" procedure. But that's done the
trick.

Thanks again!

Dennis Lovelady
http://www.linkedin.com/in/dennislovelady
--
"A hospital is no place to be sick."
-- movie mogul Sam Goldwyn

You specifed *EXT on QMHRCVPM for the message queue - the documentation
seems to say that the reply is on the reply message queue, as well as
the copy of the inquiry message. The reply message queue, it says, is
"always the sending call stack entry's call message queue".

HTH
Vern

On 7/13/2010 2:47 PM, Dennis Lovelady wrote:

Hi, Folks:



I'm trying to send a message to a program's *EXT queue for user

response,

and then process the response. But QMHRCVPM is not picking up the

response.

(I get CPF2410 (Msg key not found in message queue.)). I'm pretty

sure I've

done everything by the book - using the msg key generated by QMHSNDPM

as

parm to QMHRCVPM, et cetera - but the issue eludes me. I have posted
minimal code to recreate at http://code.midrange.com/71e3be69e2.html

and I'd

appreciate assistance!



Note: "By the book" in this case means: according to the "Inquiry

Messages"

discussion in the QMHSNDPM reference at

http://publib.boulder.ibm.com/iseries/v5r2/ic2924/index.htm?infor/apis/
QMHSN

DPM.htm. I compared against V5R3 (current version here) and don't

detect

any differences.