[WDSCI-L] Service entry points

["Mike Tobey" <Mike.Tobey@xxxxxxxxxxxxxxxxx>]

I created a service entry point for an interactive program and then called the 
program, debug started and I could debug the program, everything was fine.  I 
then created a service entry point for a batch program, I submitted the program 
but the debugger did not start and the program  ran to completion.  Are service 
entry points not valid in batch mode?

Also, after trying the batch program a few times I went back to the interactive 
one.  The service entry point no longer seems to be working (debug does not 
stop at the break point).

Any insight would be appreciated.

Michael Tobey
Applications Analyst
Foremost Farms USA
mike.tobey@xxxxxxxxxxxxxxxxx
IBM Certified AS/400 RPG IV Developer & RPG IV Programmer