Compling( Binding two modules together)

[Jeremy_Rowden@xxxxxxxxxx]

Hello everyone, 

I created a module called PNCOPYM and 
when I used the Crtpgm command to bind it with a CL 
module I created I keep getting the following message.

Definition not found for symbol 'PNCOPYM'. 
Cause . . . . . :   No definition was found for reference PNCOPYM in 
*MODULE 
  object DACOPYCL in library ULRMODS. The definition either does not exist 
or 
  is not of the same data or procedure type as the reference.  
Recovery  . . . :   Try the Create Program (CRTPGM) command again, 
supplying 
  an object that contains a definition for symbol PNCOPYM.  
 

Has anyone run into this before? If so any tips would be greatly 
appreciated
 



















Jeremy R. Rowden
Nippon Express USA, Inc.
Information Systems Division