Re: Qshell closes a couple of seconds after launching...I have a similar issue

["Rehman, Shazad" <shazad.rehman@xxxxxxxxxxxxxx>]

Hi Jon,
I've tried this and all works as expected. When I issue the wrksplf
command the spoolfiles appear and when I hit enter in the green screen
it pops back to the last
command completed screen.

Shazad


-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of Jon Paris
Sent: 07 November 2008 02:43
To: wdsci-l@xxxxxxxxxxxx
Subject: Re: [WDSCI-L] Qshell closes a couple of seconds after
launching...I have a similar issue


On 6-Nov-08, at 1:00 PM, wdsci-l-request@xxxxxxxxxxxx wrote:

> My co-workers can launch qshell but they have not upgraded to 7006.  
> I've
> not checked all their versions but they are 7004 and below. I  
> distinctly
> remember being able to launch qshell before I upgraded to 7006.

In a class we were running this week two of the students had similar  
problems just running tasks like WRKSPLF - the command was issued  
(i.e. it shows up on the 5250 RSESVR screen as the last issued) but  
the spool file display never appeared - the command just completed.   
Other similar commands had the same effect.

Can you run regular commands through the server?

Jon Paris

www.Partner400.com
www.SystemiDeveloper.com