Re: Debug getting lost?

[Jim Essinger <dilbernator@xxxxxxxxx>]

David,

I just had a thought.  I have experienced this before, but to fix it is
signed off of the display I was using to test on, and signed back on.  My
thought was that the session was using the older version of the program from
the replace library.  When I reclaimed activation groups, or signed off and
back on, it seemed to clear the problem.

You might give that a try.

Jim

On Wed, Dec 2, 2009 at 1:12 PM, David Gibbs <david@xxxxxxxxxxxx> wrote:

> Ok, is it just me ... or does SEP Debug in RDI 7.5 sometimes lose it's mind
> and not activate?
>
> I've found it happens after I've been using RDI for a while (although
> sometimes as little as 20 minutes).
>
> Basically, I set a service entry point debug and invoke the program (on
> green screen), but the SEP never hits.
>
> This happens even after I've signed off and on again.
>
> It doesn't help even if I right click on the SEP table entry and select
> refresh.
>
> The only way I can get SEP Debug to work again is to shut down RDI and
> start it back up.
>
> Any ideas?
>
> Thanks!
>
> david
>
> --
> IBM i on Power Systems - For when you can't afford to be out of business
> --
> This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
> mailing list
> To post a message email: WDSCI-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
> or email: WDSCI-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/wdsci-l.