Re: Debug getting lost?

[Jeff Buening <JeffBuening@xxxxxxxxxxxxxxxxxxx>]

   We have V5R4 box and using WDSC 7.0, and it happens also to us, but if I
Remove Service Entry Point and then Set Service Entry Point again it works
again.

  Thanks,
   Jeff Buening


message: 1
date: Wed, 02 Dec 2009 14:12:32 -0600
from: David Gibbs <david@xxxxxxxxxxxx>
subject: [WDSCI-L] Debug getting lost?

Ok, is it just me ... or does SEP Debug in RDI 7.5 sometimes lose it's mind
and not activate?

I've found it happens after I've been using RDI for a while (although
sometimes as little as 20 minutes).

Basically, I set a service entry point debug and invoke the program (on
green screen), but the SEP never hits.

This happens even after I've signed off and on again.

It doesn't help even if I right click on the SEP table entry and select
refresh.

The only way I can get SEP Debug to work again is to shut down RDI and
start it back up.

Any ideas?

Thanks!