Code Coverage Launch Configuration Not Saved

Hi,

I am trying to use Code Coverage for one of my programs, so far with less success.

I assume that the main problem is, that the code coverage launch configuration is not properly saved when clicking the APPLY and CLOSE buttons. Instead, the name of the launch configuration is incremented by one each time I open the configuration:

LOG4_X9PG0_6 (SEP)
LOG4_X9PG0_7 (SEP)
LOG4_X9PG0_8 (SEP)
...

I need to change the configuration, because I need to change the debug view for analysis from *SOURCE to *DEBUG.

Does someone else have the same problem? Any ideas of how to solve it?

I use RDi 9.5.0.2 on Windows 7 64Bit and I open the launch configuration from the context menu of the "IBM I Service Entry Points" view.

Regards,

Thomas.


--
IMPORTANT NOTICE:
This email is confidential, may be legally privileged, and is for the intended recipient only. Access, disclosure, copying, distribution, or reliance on any of it by anyone else is prohibited and may be a criminal offence. Please delete if obtained in error and email confirmation to the sender.