Re: Block printing lines in LPEX - Last Change Date

If you want "LLP" to emulate PDM (print the sequence # and change date) then you can change the default setting of the current.print.sequenceNumbers parameter by using the SET command. Simply enter the following on the Cmd line:

set print.sequenceNumbers on

------------------------------------

On 4/11/2016 11:08 AM, Duane Scott wrote:

Cannot seem to get the right combinations of search words to locate answer to being able to print the source changed date when block printing lines.

I did a bit of poking, and found that this command will print the date and sequence number but not the graphical lines created by Ctrl-Shift-O.



print selection sequenceNumbers on tokenized on



To use, make sure the date is visible in the editor, then press Escape to get to the command line. Type in the above, press Enter and I got a block to print with sequence numbers and dates.



To see all of the parameters of the Lpex print command, when you are in the command line, press F1 to summon the help. From there, click on Editor Commands. One parameter that might be of special interest, depending on the printer, is leftMargin. One can also change the font here, too.

-------------------------