|
midrange.com
Dave,
You might try the code/400 mail list, code400-l@borzak.com. We experienced
similar
problems trying to get code running. The manuals were useless and we don't
have
the paid support option. It took us over 100 hours to get it to run. The root
of our
problem was we were using a token ring card and our router did not support
source
based routing. I don't think I would hold out MS as the standard bearer for
service. We
spend a similar amount of time getting their products to run, and a lot more to
keep them
that way. IE: We just found a solution by chance to a nagging internet
explorer
problem, Microsoft support long ago told us no solution exists.
Have you looked at the device entry? CHGICFDEVE FILE(EVFCICFF) PGMDEV(CODE).
When I "roam" to a new device I have to change the device name. Don't know if
this
applies in your environment.
Deepest sympathy,
David Morris
>>> Dave Mahadevan <mahadevan@fuse.net> 03/24 11:11 AM >>>
Chris Rehm wrote:
> ** Reply to note from Dave Mahadevan <mahadevan@fuse.net> Mon, 23 Mar 1998
>18:11:37 -0500
>
> > I get EVF0001 (Faled to establish commnication session with the
> > workstation).. I suspect it is using SNA not TCP. How do I make this
> > thing do TCP? or is this an option not available for the lowly V3R2
> > folks?
>
> Did you create the requisite ICF file?
>
Yes. Using CRTDUPOBJ as instructed in the getting started document.
Here is what I am doing. Starting the TCP/IP Daemon on the PC. Then issuing
the STRCODE on
an AS/400 Session. Here is what happens.
STRCODE RMTLOCNAME(DAVE)
License information not retrieved.
License information not retrieved.
License information not retrieved.
License information not retrieved.
The job's CCSID value is changed from 65535 to 00037 while the STRCODE
command is active.
Device changed in file EVFCICFF in library STLLIB.
Remote location DAVE for program device CODE was not found.
Failed to establish communication session with the workstation.
WRKLICINF shows the products as licensed.
The STRCODE does not have the communication type parameter available even if
using F9 to
display all parms.
I just dont want to use NS/Router. This thing is forcing my hands....
CODE/400 oops ADTSCS is turning out to be poorly marketed, supported, and
dispatched. The
six installation tapes had wrong labels on the outside. The publications did
not ship saying
they already sent it to me a while back... after complaining... it just arrived
by Airborne
... support for the product you say... IBM says no support line no support not
even for
brand new off the box software ...did somebody say MS ... geez...wish IBM
gets their act
together before Redmond eats them for breakfast ...
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
