RE: CONFIGURING SMTP E-MAIL ON AS/400

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

Try adding your domain onto your mail router.  Ours is
mailsrv.cross-check.com and we have a host entry as mailsrv.cross-check.com
We are using exchange as our mail server also.  This is for outbound AS400
based e-mail only.  Now if you have mail routing turned off on the NT, it
will discard your e-mail.  Have your NT administrator check for this.

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

-----Original Message-----
From: Angela Wawrzaszek [mailto:wawrzaszeka@AUSTEEL.com]
Sent: Wednesday, December 13, 2000 10:30 AM
To: Midrange Mail List (E-mail)
Subject: CONFIGURING SMTP E-MAIL ON AS/400


I am trying to configure the AS/400 so that I can use either the SNDDST
command or the SNDEMAIL command from the News/400 article.
 
This is what I did:  
 
1.   CFGTCP,  option 10,  we have our  exchange server set up as a
host-table  name = AUSTEEL
 
2.    Created a DIRE:
                                       User ID =  INTERNET
                                       Address = GATEWAY
                                       System Name=  INTERNET
                                       User Profile  =  blanks  
                                       Network User ID = *USRID
 
                                       Mail service Level = User index 
                                       Preferred Address = NETUSRID
*IBM
                                           Address Type  =   ATCONTXT
 
3.   CHGSMTPA     autostart(*yes) 
                                 mailrouter('AUSTEEL')  
                                  Firewall(*YES) 
 
 
4.  I can ping to AUSTEEL,  and SMTP  server is started.
 
 
5.    SNDDST TYPE(*LMSG) TOINTNET((wawrzaszek@austeel.com)) DSTD('test email
des
cription') LONGMSG('Testing email')   
 
                   OR
 
                                                            
 SNDEMAIL ADDRESSEE((WAWRZASZEK@AUSTEEL.COM ANGIE)) SENDER(MCLOUGHLIN@AUSTE
EL.COM MICHELLE) SUBJECT(TEST) MESSAGE('Testing using sndemail')

 
I get back a Send Distribution completed successfully.  or   message
Sending email......
 
 
 
But the message never goes anywhere.  I am assuming I do not have something
set up correctly.  I looked at 2 web sites   www.bytware.com and
www.way.org.   and it looks okay.    
 
Can someone help me out?    Thanks!
 
                                     
Angie Wawrzaszek 
M.I.S. Department 
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---