Re: backups on AS/400, objects missing -- auto-run procedures

[barsa@xxxxxxxxxxxxxxxxxxx]

If you run the TAA Tool Check Save/Restore Job Log for Problems (CHKSAVRST)
command, specifying ERRORSONLY(*YES), you wile get a short easily scannable
for errors.

Al - back from COMMON - but still not recovered

Al Barsa, Jr.
Barsa Consulting Group, LLC

400>390

914-251-1234
914-251-9406 fax

http://www.barsaconsulting.com
http://www.taatool.com





                                                                                
                                         
                    "Chuck Morehead"                                            
                                         
                    <cbmorehead@nokuse.        To:     
<MIDRANGE-L@midrange.com>                                         
                    com>                       cc:                              
                                         
                    Sent by:                   Subject:     Re: backups on 
AS/400, objects missing  -- auto-run          
                    owner-midrange-l@mi        procedures                       
                                         
                    drange.com                                                  
                                         
                                                                                
                                         
                                                                                
                                         
                    05/21/01 08:40 AM                                           
                                         
                    Please respond to                                           
                                         
                    MIDRANGE-L                                                  
                                         
                                                                                
                                         
                                                                                
                                         




Steven,

If you find that objects are "missing" from your tape I suggest checking
the
job log of the backup job.  It is most likely that the objects were in use
when the save was performed and they were not saved.  If your backup job
does not create a job log I would suggest changing the logging level of the
job to (4 00 *SECLVL).  I can't tell you where to make this change w/o
knowing how the backup job is submitted (IBM job scheduler, manaully, etc.)

I personally have never seen an IBM save skip objects unless they were in
use.

Chuck

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---




+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---