RE: Problems with SMTP & MSF- HELLP!!!!!

["Phil" <sublime78ska@xxxxxxxxx>]

Arlene,

Note: I don't have Domino installed and know nothing about it.

Try using the STRMSF command with 10 jobs rather than the default 3 (or a
few numbers higher than what it is set for on your system).  There is
probably a bad message out there that is ending the MSF jobs but if you have
enough MSF jobs starting you may get by the problem.

I have some notes on fixing an stmp problem but I think it was a V4R3
problem (when a user omitted the .com on their email address).  I've had
your problem too but I don't recall the resolution, although the work around
was to STRMSF with more than the default 3 jobs.  It may have been an IPL
and until I IPL'd I started MSF with more than 3 jobs.  Or IBM may have done
something.

Phil



> -----Original Message-----
> From: midrange-l-admin@midrange.com
> [mailto:midrange-l-admin@midrange.com]On Behalf Of
> Arlene_M_Soderlund/NFCNA.COM@NFCNA.COM
> Sent: Thursday, August 23, 2001 1:04 PM
> To: midrange-l@midrange.com
> Subject: Problems with SMTP & MSF- HELLP!!!!!
>
>
>
> We are on V4R4 -   and yes that is Hell with a "P"
>
> 1.   Normally send mail using the SNDDST command,  this was
> working up to a
> few weeks ago.
>
> 2.  MSF jobs do not start upon the start  of the SMTP server anymore!
>
> 3.  Until we go to V4R5, we cannot  call IBM, non supported
> release =  lots
> of  $$$$$$$$$$$$$$$$
>
> 4.  WE used the strmsf commmand and got a backlog of snddst out,
> however it
> stopped working for the following reasons.
>
> 5.  Any new messages want to call an exit point program in library Qnotes,
> we tried to put notes on our as/400 many moons ago,   decided against it
> and uninstalled.
>
>
> Message ID . . . . . . :   CPFAF95
> Date sent  . . . . . . :   08/23/01      Time sent  . . . . . . :
>
> Message . . . . :   MSF job 587558/QMSF/QMSF ended. Reason code 04.
>
>
> 04 - Exit point program QANIADDR in library QNOTES for exit point
>   QIBM_QZMFMSF_ADR_RSL failed in the MSF job.
>
>
>
> 6. We started the journalling but that tells you nothing too.
>
>
> 7. I will try to add the Dump debug exit point as explained in the TCP
> book. But why is the QNOTES program in my exit point?  Can I take it out ?
> Substitute??     We are current on PTF's and plan on going to V4R5  on
> soon.
>
>
>
> Thanks  for advice you can give! `
>
>
>


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com