Re: 2838 10/100 Ethernet adapter full duplex mode

[Mike Buglass <mike.buglass@xxxxxxxxxx>]

Jay Maynard <jmaynard=NaA3cy51gWZfq8cQ1yknNg@public.gmane.org> wrote
in 20021004133550.A14859@thebrain.conmicro.cx:">news:20021004133550.A14859@thebrain.conmicro.cx:

> On Fri, Oct 04, 2002 at 10:06:12AM -0700, Kirk Goins wrote:
>> Is the 170 attached to a HUB or a SWITCH ? A lot of HUBS are
>> *half duplex.
>
> This is definitely a switch, specifically a D-Link DSS-16+.
>
>> I had a problem once after and OS upgrade where the 400 wasn't
>> auto detecting correctly and manual settings of other than 10 and
>> half would not work. I finally did a rtvcfgsrc, deleted the line
>> and re-created it. Everything worked fine afterwards.
>
> Might have to try that...
> _______________________________________________


Jay,


Is the switch port configured for full duplex or auto duplex?
If it is set as auto duplex then it will not work properly if connected
to a card configured as full duplex.  You will need to configure both
the switch port and card to a consistent setting - either both AUTO or
both FULL.



--
Mike Buglass