RE: interactive subsystem creation

[Neil Palmer <neilp@xxxxxxxxxxx>]

Thanks Chris (and Andy) for the right answer.  :-)

...Neil




Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx> 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
2003/09/03 00:21



To
"'Midrange Systems Technical Discussion'" <midrange-l@xxxxxxxxxxxx>
cc

Subject
RE: interactive subsystem creation






Close,  ADDWSE PCKATO* for the new subsystem AT(*SIGNON) and the same but
AT(*ENTER) for QINTER.  The QINTER will not grab PCKATO* at the signon
screen.  DO NOT REMOVE the *all WSE.

Chris Bipes

-----Original Message-----
Sent: Tuesday, September 02, 2003 6:30 PM
To: Midrange Systems Technical Discussion
Subject: Re: interactive subsystem creation


One method.  You will need the ADDWSE PCKATO* for your new subsystem with 
AT(*SIGNON).  You need to remove the *ALL Workstation Entry from QINTER, 
but this may entail adding a whole host of other wild card names to pick 
up other devices not to be allocated to your new subsystem (A* B* C* D* 
etc. - and handling devices other than PCKATO* beginning with P will be 
fun).  Or possibly you could use type entries, if all devices in MYINTER 
are a specific type that are not used in QINTER.
_______________________________________________