Cannot figure out SNADS transfer problem

[jmoreno@xxxxxxxxxxxxxxxx]

Hello all,

I have two systems and I can SNADS (files and/or spooled files) from system
A to System B with no problems.
However from System B to System A,  I cannot SNADS (files and/or spooled
files). I just run into problems.
No error logs, no QSYSOPR messages no History messages. I cannot figure it
out.
The System Storage threshold is set at 95 % and we are running at 88%.
I have ended and restarted the QSNADS subsystems, all the Host servers.
Started the TCP Server *DDM
and yet .. the files and/or spooled files do not get to the target system
..


Where else should I look for ?

Your advice will be greatly appreciated.

Jorge Moreno
Overseas Military Car Sales
Woodbury, New York

+ - - - - - - - - - - - - - - - - - - - - - - - -
This email, including its attachments, may contain information that is
confidential and may be protected by federal and/or state laws and
regulations, or other confidentiality privileges.  This email, including
its attachments, may contain non-public information; therefore it is
intended to be conveyed only to the designated recipient(s).  If you are
not an intended recipient, please delete this email, including its
attachments, and notify the sender.  The unauthorized use, dissemination,
distribution or reproduction of this email, including its attachments, is
prohibited and may be unlawful.
+ - - - - - - - - - - - - - - - - - - - - - - - -