RE: echo back problem

["Lim Hock-Chai" <Lim.Hock-Chai@xxxxxxxxxxxxxxx>]

I think I should mention that the new configuration is working because when I 
use ibm's STRITF command, it seems to be able to communicate with the terminal 
just find.  However, in my application, I'm receiving the same data that I sent 
to terminal.  I'm thinking that STRITF can handle echoing.  My app is not 
written to handle it.  But my question is that what is causing the echoing?
 

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of Lim Hock-Chai
Sent: Thursday, December 30, 2004 2:30 PM
To: Midrange Systems Technical Discussion
Subject: RE: echo back problem


Note:  What we try to do is get rid of the remote router without any 
programming change.  Below are diagrams


Typical setting:
  -----    x.25 over v.35      ------------      Convert x.25 to ip     
-------------  Covert back to x.25   ---------
 |AS400|--------------------> |Cisco Router| ------------------------->| Cisco 
Router|--------------------->| Terminal|
  -----                        ------------                             
-------------                        --------- 


Want to do this (because this new terminal support ip connection):
  -----    x.25 overv.35       ------------      Convert x.25 to ip     
---------
 |AS400|--------------------> |Cisco Router| ------------------------->| 
Terminal|
  -----                        ------------                             
--------- 

is above possible without changing application?