RE: IPDS Inactivity Timer

["Wilt, Charles" <CWilt@xxxxxxxxxxxx>]

You need to make use of a *PSFCFG object.

GO CMDPSFCFG.

On the device description, assign the PSF configuration you created above via 
the USRDFNOBJ param.

*IPDS printers should normally always have a PSF config object assigned.

For more info:
http://www-912.ibm.com/s_dir/slkbase.NSF/643d2723f2907f0b8625661300765a2a/516c5f9756b1368a86256690004c3af3?OpenDocument&ExpandSection=6,5#_Section4

or

http://tinyurl.com/98lph


HTH,


Charles Wilt
iSeries Systems Administrator / Developer
Mitsubishi Electric Automotive America
ph: 513-573-4343
fax: 513-398-1121
 

> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of
> ChadB@xxxxxxxxxxxxxxxxxxxx
> Sent: Tuesday, May 03, 2005 11:24 AM
> To: 'Midrange Systems Technical Discussion'
> Subject: IPDS Inactivity Timer
> 
> 
> 
> 
> 
> 
> 
> We're getting used to some new IBM 1145 Multifunction printers that we
> recently installed and are noticing a delay after a job prints from an
> AS/400 outq.  For around 40 seconds after the job prints, the printer
> display shows 'busy network' and then goes back to ready 
> status (and then
> is available for a copy/fax/network job).  In the interest of reducing
> contention for the printer,  i'm wanting to decrease the 
> delay before the
> next job will kick in.
> 
> I'm pretty sure the setting I need to adjust is the "inactivity timer"
> setting on the printer device description (i'd like to set it 
> to *SEC15,
> which looks to be the minumum), but am not able to bring up 
> this setting.
> The device is configured as *IPDS instead of a 3812.  Is this 
> not something
> that can be adjusted when configured as *IPDS?
> 
> Thanks for any possible advice from someone who knows!
> 
> ______________________________________________________________
> _______________
> Scanned by IBM Email Security Management Services powered by 
> MessageLabs. For more information please visit http://www.ers.ibm.com
> ______________________________________________________________
> _______________
> -- 
> This is the Midrange Systems Technical Discussion 
> (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
> 
>