Re: 3197 Address Setup

[Keith Carpenter <carpcon@xxxxxxx>]

Matt Gross wrote:
> As a follow-up to the IPL halt, I wanted to check that the console was set to 
> address 0.  It is definitely at Port 0 on the "Brick".
>    
>   I held down the space bar and turned on the display.  In the far-right 
> lower corner, there are two dashes "--".  I'm pretty sure this is where the 
> address should display.
>    
>   Does anyone know how I can set the address - I haven't done this in a long 
> time.  Each time I would press a key, "9013" would appear and I'd have to use 
> the reset key.
>    
>   TIA,
>    
>   Matt

After powering on with the space bar depressed,
Try F23 to cycle thru the addresses (0-7) for the 1st session.

F24 sets the second session's address
F20 should set the second session type (display or printer)