Re: New version of HMC.

[Tommy.Holden@xxxxxxxxxxxxxxxxxxxxx]

thanks for the info Rob.  hopefully i'll get to upgrade the HMC here.  it 
hasn't been updated since 2005....new jobs are fun when nothing has been 
PTFed, updated, etc for over 2 years....not.....

Thanks,
Tommy Holden



rob@xxxxxxxxx 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
08/09/2007 08:15 AM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
cc

Subject
New version of HMC.






Loaded 7.3.1.0 of HMC (after getting my firmware up to an appropriate 
level).
Loaded on MH01015, MH01030, MH01041 on the HMC.
The interface is very nice.  Only those used to the old version, and could 

click on the right thing blindfolded, might complain.
Some small quirks like trying to start the 5250 session was a bit, well, 
quirky, but I got it done.
Can't really duplicate the 
ServerI
     Partition1
     Partition2
     Partition3
ServerII
     PartitionA
     PartitionB
screen.  I could get a group screen that listed
     Partition1
     Partition2
     Partition3
     PartitionA
     PartitionB

Remote access to the HMC was incredibly easy to set up (once I found the 
documentation).  I went into:  HMC Management, Administration, Remote 
Operation and changed it from disabled to enabled.  Then I used a browser 
to go to https://myhmc   Remember, that is httpS, not just http.  First 
time I had to install a certificate.  Now I get the full GUI easily. Other 

than installing the certificate (when prompted), and allowing popups for 
this site, there was nothing to configure or install on the PC.

I don't have access to 5250 sessions started on the HMC via this method. I 

still had to use iSeries Access for Windows and change:
Communication, Configure, System Name
Communication, Configure, Properties, Use default User Id, prompt as 
needed
Communication, Configure, Properties, User ID  Q#HMC
Communication, Configure, Properties, Security, Not Secured
Communication, Configure, Type of emulation, Display, leave size at 24x80.
Communication, Configure, Port number, 2300, not the default of 23.
Make sure when you start 5250 sessions on the HMC you make them shared and 

not dedicated.

Rob Berendt