load source concurrent maintenance

["Ian Carag" <Icarag@xxxxxxxxxxx>]

Hello everyone!

My load source just failed on me and I've been searching the archives for the possibility of replacing the disk through concurrent maintenance. 
I've talked to different SEs and each have a different opinion on how I should recover my load source. Some say concurrent maintenance is possible and 
I could replace and rebuild my load source, while others say it isn't and I should do a scratch-install.

So far the solution I came up with from the archives is to:

1. Install a non-configured disk
2. IPL to DST, Copy disk data unit to non-configured disk
3. Power down
4. Replace load source disk with non-configured disk
5. IPL

regards,
ian



This email message and any files transmitted as an attachment are intended for the named recipient only. It may be privileged and/or confidential. If you are not the intended named recipient of this email then you should not copy it or use it for any purpose, nor disclose its contents to any other person. You should contact The Saudi Investment Bank as shown below so that we can take appropriate action at no cost to yourself.

The views or opinions expressed in this email are solely those of the author and are not necessarily those of The Saudi Investment Bank. The recipient should check this email and any attachments for the presence of any Viruses. The Saudi Investment Bank does not accept any liability for any damage caused by any virus / error transmitted by this email.

The Saudi Investment Bank, PO Box 3533, Riyadh 11481, Saudi Arabia