Sounds like you need to up your assistance level. (This user preference setting has been around as long as I have been around these systems.)
Right from the WRKUSRPRF display, take function <F21> and set your assistance level to Intermediate.
FYI.....this applies to other commands where output is intended to be displayed, work system status comes to mind as an example.
________________________________
From: Robert Ostrowski <Bob.Ostrowski@xxxxxxxxxxxxxxxx>
To: midrange-L@xxxxxxxxxxxx
Sent: Tue, April 13, 2010 1:08:17 PM
Subject: V6.1 WRKUSRPRF
We are testing a newly installed system with V6.1. When I ran the
command WRKUSRPRF and prompted a user and put a 2 on it to change, I got
an extremely limited version of the command. I could not add any
authorities or much else. The only way was to use the CHGUSRPRF
command. Is this some new security "enhancement" for V6.1?
This mailing list archive is Copyright 1997-2026 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
