Re: Moving TO BRMS

[Jim Oberholtzer <midrangel@xxxxxxxxxxxxxxxxx>]

Yes, you can continue to use all the normal save/restore commands.  The 
problem will be all the exit points needed for tape management and tape 
library management might not be set properly if the old librararian 
software was on the system at the same time as BRMS.

Check exit points:

QIBM_QTA_STOR_EX400   EX400200     *YES
QIBM_QTA_STOR_EX400   EX400300     *YES
QIBM_QTA_TAPE_TMS     TMS00200     *YES

and

QIBM_A1A_RETR_INF     RTVI0100     *YES
QIBM_A1A_TAPE_INF     MEDI0100     *YES
QIBM_A1A_TAPE_MOVE    MEDM0100     *YES

to be sure they are correct.



Jim Oberholtzer
Chief Technical Architect
Agile Technology Architects


On 2/18/2013 9:12 AM, Gord Hutchinson wrote:
> With our move to new hardware, we are migrating to BRMS from another tape
> librarian.
>
> Until we have time to develop our control groups&  policies, etc, is it
> possible to use BRMS simply as a tape librarian and contnue to use the
> 'normal' SAVOBJ/LIB commands?
>
> I know this is not the optimum but it would only be a temporary measure.
>
>
> Gord
>
>
>
> -- Gord Hutchinson TST Overland Express
> --