SAVE 21 remote hmc and pc energy saver

Our admin ran a save21 from his laptap remoted into hmc.
All was running well till laptop energy saver blacked out the display.
Was an hour into it.
He went to HMC and had blank screen for console.

Used web access of tape library to monitor activity.
Save 21 kept running, and tape drive was set to autoload. Not using BRMS.
V7r1
It kept running (3 more hours, including load of 2nd tape) and completed
the save 21
In previous releases I've seen this fail. The CPF5080 has "ignore"
thoughout log.



CPF5140 Diagnostic 70 09/28/14 18:17:56.041199
QWSERROR QSYS 0630 QWSUIEH
Message . . . . : Session stopped by
a request from device DSP01.


CPF5503 Diagnostic 30 09/28/14 18:17:56.041241
QWSERROR QSYS 0652 QWSUIEH
Message . . . . : Input or Output
request failed. See message CPF5140.


CPF5080 Notify 30 09/28/14 18:18:06.437840
QWSDSMSG QSYS 0546 QMHSNSTA Q
Message . . . . : Display status
message request failed. See message


CPF5263.
Cause . . . . . : Various error
conditions detected. Recovery . . . :
Close the active file, if any, and
see the message CPF5263 for corrective
action. Correct the errors and then
try the request again. Possible choices
for replying to message . . . . . .
. . . . . . . . . : I -- Ignore the

request.
*NONE Reply 09/28/14 18:18:06.437844
QMHSNINQ QSYS 0F84 QMHSNSTA Q
Message . . . . : I



Jim Franz