We have a new Power9. We have opted to use a LAN console over an HMC.
(Single LPAR system). So far with this system (not in production yet), we
are spending most of our time trying to recover the console. Seems each
time an IPL is performed the console address (and sometimes even the card)
is changed. I have been working with IBM support on this, but sometimes the
folks on this list have experiences that are outside of support's knowledge
base.
We have gone through more 65-21-11 sequences than I can count (I am
beginning to think we may wear those buttons out - lol). Once we finally get
the console configured we go into SST and set the IP (using an IPV4
address). IPL and it has an IPV6 address for the console or the console
cannot be found.
Any thoughts from the gurus?
Regards,
Jim Hawkins
Programmer Analyst
Interkal LLC
Kalamazoo, MI
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
