Re: TOSHIBA ES3515AC

[Don Brown <DBrown@xxxxxxxxxx>]

Hi Roberto,

Thank you for the config.

I have created a new device description with your sample and it fails to 
establish a SNMP connection to the printer - I have an open case with 
Toshiba, will keep you posted.

CPD401A  Message . . . . :   Could not establish SNMP communications with 
device 

Cause . . . . . :   Was not able to establish SNMP communications with 
device 
  SCCPRT05. The reason code is  3.  The reason codes and their meanings 
are as 
  follows: 1 - The device appears to be an SNMP device but not a printer. 
2 - 
  The device appears to be an SNMP device but does not support the 
required 
  level of an industry standard SNMP protocol. 3 - Communication with the  
 
  device timed out.  This could occur because of heavy network traffic, 
the 
  device is not an SNMP device, or the read community name set on the 
device 
  is different than expected. Recovery  . . . :   Make sure that the 
device is 
  a printer that supports the industry standard SNMP protocol and that the 
 
  read community name is set correctly.  Then try the operation again.   



Don Brown 
 





From:   "Roberto Tempesti" <robertotempesti2@xxxxxxxxx>
To:     midrange-l@xxxxxxxxxxxxxxxxxx
Date:   03/08/2020 10:02 PM
Subject:        Re: TOSHIBA ES3515AC
Sent by:        "MIDRANGE-L" <midrange-l-bounces@xxxxxxxxxxxxxxxxxx>



Il 03/08/2020 13:00, Don Brown via MIDRANGE-L ha scritto:
> I am out of the office.
>
> If you have a suggested config you can share I will try tomorrow.

This configuration could be a good start point:

CRTDEVPRT  DEVD(yourdevice) DEVCLS(*LAN) TYPE(3812) MODEL(1) +
              LANATTACH(*IP) PORT(9100) ATTACH(*DIRECT) +
              ONLINE(*YES) FONT(011 *NONE) +
              FORMFEED(*AUTOCUT) SEPDRAWER(*FILE) +
              PRTERRMSG(*INQ) MSGQ(*CTLD) ACTTMR(170) +
              INACTTMR(*SEC15) LINESPEED(19200) +
              WORDLEN(8) PARITY(*NONE) STOPBITS(1) +
              TRANSFORM(*YES) MFRTYPMDL(*HPCOLORLJ) +
              PPRSRC1(*LETTER) PPRSRC2(*LETTER) +
              ENVELOPE(*NONE) ASCII899(*NO) +
              IMGCFG(*NONE) CHRID(*SYSVAL) +
              RMTLOCNAME('xxx.xxx.xxx.xxx') +
              SYSDRVPGM(*IBMSNMPDRV) +
              PUBLISHINF(*UNKNOWN *UNKNOWN *UNKNOWN +
              *UNKNOWN *BLANK *UNKNOWN) TEXT('Toshiba +
              ES3515AC')

A feedback could be helpfull.