O would find the manual for that printer that will have the commands. That
should tell you what you need to know.
On Mar 18, 2010 8:28 AM, "Burns, Bryan" <Bryan_Burns@xxxxxxxxxxxx> wrote:
The following commands, sent as a file to a Zebra QL420plus printer,
changed the printer to stop feeding labels about 3 mm after the tear-off
perforation (the feed was previously stopping a few millimeters short of
the tear-off bar).
~jc^xa^jus^xz
! DF RUN.BAT
! UTILITIES
PRESENT-AT 50 2
PRINT
Does this mean anything to anyone? What number would I change to shorten
the feed by about 3 mm?
Bryan Burns
--
This is the PC Technical Discussion for iSeries Users (PcTech) mailing list
To post a message email: PcTech@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/pctech
or email: PcTech-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/pctech.
As an Amazon Associate we earn from qualifying purchases.