Re: Printer commands

[Bill <brobins3d@xxxxxxxxx>]

Burns, Bryan wrote:
> The following commands, sent as a file to a Zebra QL420plus printer,
> changed the printer to stop feeding labels about 3 mm after the tear-off
> perforation (the feed was previously stopping a few millimeters short of
> the tear-off bar).

I can interpret them for you, but can't really tell you how to fix it.

> ~jc^xa^jus^xz

Set Media Sensor Calibration  (likely what caused the change)
Start of Label Format
Save Current configuration settings  (why it's now permanent)
End of Label Format

> ! DF RUN.BAT

Store format commands as a string to be later merged.  I believe the 
remaining are related to this.

> Does this mean anything to anyone? What number would I change to shorten
> the feed by about 3 mm?


Doesn't sound like modifying any of these commands will fix your 
problem, except to stop doing the Media Sensor Calibration.  I got this 
info from a ZPL programming manual.

Bill