Did that.
Personally I think it is more of a PC issue than a System i issue. One of
the things I came across in the Info Center said something (been awhile)
about setting up a workgroup. Couldn't find that in the Control Panel or
any subgroup. Where does one go to define a workgroup (XP, if it matters)?
Jerry C. Adams
IBM i Programmer/Analyst
If Lincoln were alive today, he'd roll over in his grave. - President Gerald
Ford.
--
A&K Wholesale
Murfreesboro, TN
615-867-5070
-----Original Message-----
From: pctech-bounces@xxxxxxxxxxxx [mailto:pctech-bounces@xxxxxxxxxxxx] On
Behalf Of Pat Barber
Sent: Wednesday, April 20, 2011 9:40 AM
To: PC Technical Discussion for iSeries Users
Subject: Re: [PCTECH] Mapping a Network Drive (iSeries Folder)
So....you can access the system using Navigator
but you can not map a drive ?
Most new(er) systems seem to come with Netserver ready to go.
I just set up a older 520 with V7R1 and other than setting up the
share, that was all I had to do to get things working.
I assume you followed these steps:
http://publib.boulder.ibm.com/infocenter/iseries/v7r1m0/index.jsp?topic=/rza
ij/rzaijconnetas.htm
On 4/19/2011 10:48 AM, Jerry C. Adams wrote:
Pat,
The folder is shared; it shows up in iNav's File Shares panel.
midrange.com
